Navigace

CB 9066 Gel Remover for Cyanoacrylate Adhesives

We extended our D-Bonder Remover line with CB 9066. This Remover is based on the known and well recognised CB 9065, but it has got thixotropic flowing behaviour. This improves the covering of the to be removed adhesive in a better way.

Our Remover line has got 3 grades by now:

  • CB 9060 D-Bonder (mainly for industrial purposes)
  • CB 9065 CA Remover (liquid, but less aggressive than CB 9060)
  • CB 9066 CA Gel Remover (like 9065 in Gel)

TDS CB 9060 series

The CB 9060 D-Bonder series softens, dissolves and removes Cyanoacrylate Adhesives. In contrast to traditional solvents the product is notable for its almost non-combustibility (flashpoint 123° C).

CB 9060 D-Bonder series is designed for use with the Cyberbond line of Cyanoacrylate Adhesives. The products are colourless. CB 9060 and CB 9065 are liquid; CB 9066 comes as a Gel which allows a better control of application and a longer dwell time.

CB 9060 is for industrial use only. It is made:

  • For cleaning Cyberbond’s LINOP dosing equipment, with the advantage that it does not leave any condensation, moisture inside the system. CB 9060 prevents possible pre-polymerization of the adhesive within the dosing system.
    The easiest way for use is to replace the 500 g Cyanacrylate bottle in the pressure pot by a 500 ml CB 9060 one. Then apply the CB 9060 D-Bonder like the adhesive, just hold an empty Cyanoacrylate bottle below the valve. Continue this till all Cyanoacrylate is out of the tubing and valve and CB 9060 is applied instead. The LINOP Equipment can be put on the shelf for unlimited time now. If you want to use the equipment again for dosing adhesive, proceed accordingly and replace the CB 9060 D-Bonder by a Cyanoacrylate.
  • CB 9060 can also be used to clean dosing tips, tools etc. that have been in contact with Cyanoacrylate Adhesives. Just apply CB 9060 in a suitable container (e.g. glass) and put the contaminated parts inside. Allow several minutes respectively hours before cleaning or wiping it away from substrate surface. Depending on the quantity of adhesive being removed, additional applications of CB 9060 D-Bonder may be necessary. When attempting to remove bonded parts, soaking them for an extended time is maybe necessary. NOTE: May adversely affect some plastics, coatings etc. Test first.

CB 9065 and CB 9066 can be used for cleaning purposes.

If clothing, tables or other unwanted areas are contaminated with Cyanoacrylate Adhesive, you might have a chance to clean these pieces with CB 9065 or CB 9066. Very important is to make trials at non visible parts beforehand to avoid that the D-Bonder destroys surfaces, bleaches cloths etc.

After applying CB 9065 or CB 9066 allow the D-Bonder a certain time to dissolve the adhesive before cleaning or wiping it away from the substrate surface. Depending on the quantity of adhesive being removed, additional applications of CB 9060 D-Bonder may be necessary. When attempting to remove bonded parts, soaking them for an extended time is maybe necessary.

The main active agent is a heterocyclic ketone.

 

Precaution Sentences: Xi irritant / Irritating to eyes / Wear suitable protective clothing, gloves and eye/face protection